Caractéristiques :
Extruded aluminium module
Numeric keypad.
Stainless steel covered buttons with enable / disable acoustic acknowledgement signal on push.
2 output relays with 8 activation codes each one and independent panic code.
4, 5 or 6 digits programmable codes.
One code can be programmed to activate more than one relay.
Relay 1: N/C or N/O, single shoot or stable software programmable.
Relay 2: single shoot with three contacts (N/C or N/O).
Programmable activation time from 0 to 20 seconds in single shoot mode.
After introduction of 3 wrong consecutive codes, in a period of less than 15 seconds, the access
control is disabled during 3 minutes. After this time, if 3 wrong consecutive codes are introduced
again, the disabled time is doubled up to a maximum of 12 minutes.
12Vd.c. battery input without charge management.
Proximity reader.
Up to 600 users using ISOPROX or KEYPROX proximity tags .
Several tags can be recorded in the same memory position.
System programming through the internal keypad. A PIN code is required for system management.
Seven segments memory display.
1 output single shoot relay with programmable activation time.
Dimensions :
External: 134(W) x 148(H) mm.
Embedded: 125(W) x 140(H) x 56(D) mm.
KIT CONTRÔLE D'ACCÈS A CLAVIER
- Modèle : 4301/AL
- Disponibilité : Pré-Commander
-
1 503,17MAD
- H.T : 1 252,64MAD